K0750 Boom Kicker by Tylaska (20′-25′ Boats) – Black
$231.00
- Robust fiberglass and aluminum construction
- Suggested Boat Size – 20-25 ft
- Initial Pin to Pin – 36 in
- Maximum Pin to Pin – 31 in
- Maximum Force (1) – 250 lb
- Stroke –
- Initial (2) – 11 in
- Min (3) – 6 in
1. At Maximum Pin to Pin length.
2. Maximum stroke at initial Pin to Pin
3. Maximum stroke at min. Pin to Pin. Stroke is travel when flexed. 1″ of stroke equates to approximately 7″ at the aft end of the boom.
* Uses webbing sling at boom instead of track fitting.
Boomkickers use two coated solid fiberglass spring rods to provide the force necessary to support the boom and mainsail. The rods are clamped into teflon coated, anodized aluminum end pieces and attached to universal mast and boom fittings. Fittings are included along with machine screw fasteners, the proper drill and tap and hex wrench. The mast fitting includes a round slide which, used in the luff groove, avoids drilling into the mast. Flat slides in varying widths are available from the factory. The slides can often be inserted at the sail opening above the gooseneck and slid down reassembling the fitting in position. If slides are not usable, the fitting can be attached directly to the mast using the same drill and tap provided for the boom. The custom extruded boom track is contoured to fit both round and flat bottom booms. The track has an adjustable clevis pin to set the maximum height the Boomkicker will lift the boom. The track length forward of the pin allows the boom to move higher if needed.
